A machine that appears narrow on paper can still be too wide with its bucket, coupler or planned attachment. Before asking for a compact skid steer quote, measure the complete route and distinguish chassis width from overall machine width.
Measure the tightest point on the whole route
Measure gates, door clear openings, guard rails, temporary fencing and the space beside stored materials. Note the actual usable width after protruding hinges or protection boards. Then record the surface, any change in level and space to turn after the opening. A dimension at one straight doorway cannot answer whether the loader can turn, unload or reverse safely inside.
Compare chassis width with fitted bucket width
The brochure lists an 865 mm vehicle width for C1200, but a 1045 mm bucket width and 2867 × 1045 × 1499 mm overall dimensions. For V800, it lists a 911 mm vehicle width and a 1020 mm bucket. The V1000 lists a 960 mm vehicle width and a 1240 mm bucket. These figures show why a body-width claim alone can mislead a buyer planning a gate. Do not assume a different bucket is approved without checking the mounting and machine manual.
Check height, slope and delivery as well
Compare the published height with the lowest overhead obstruction. Measure the trailer ramp and turning area before unloading. A slope, loose gravel, drain cover or step may change the access plan even when the width is sufficient. Keep an allowance for safe passage and operator visibility according to the equipment manual and site procedure; the minimum allowance depends on the actual route and configuration.
Use a five-item inquiry sheet
- Send the narrowest clear width and lowest clear height with photos and a scale.
- Provide a sketch of turns, slopes, steps and overhead lines.
- State the material, daily task and required rated load.
- Identify the intended bucket or attachment, not just the loader body.
- Ask for a dimension drawing of the quoted configuration, including the transport setup.
If the project is especially tight, compare the T360 with the models above and review the entire working envelope. See the wheel-versus-track model table for more options.
Send your access dimensions
Share a doorway or gate photo, measured width and height, and the required attachment. We can match those details against the model pages before preparing a quote.
Discuss Your Site →Specifications in this guide are from the supplied 2026 product brochure. Confirm final figures, permitted use and attachments against the specific machine documentation before ordering.
